• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

The flush plate itself is usually the first point of failure a customer notices, whether that is a button that has stopped actuating, a plate that has come loose from the wall, or a dual-flush mechanism that only performs a full flush regardless of which button is pressed. Because the plate connects to the cistern through a spindle or cable rather than sitting directly on top of it, the fault could sit at the plate, along the linkage, or at the flush valve itself, and each of those needs a different part.

A flush valve, by contrast, works as a straightforward seal at the base of the cistern that lifts to let water fall directly through into the pan under gravity, with no siphoning action involved, and shuts again once the float or timer mechanism allows it to reseat. Flush valves are what almost all dual-flush cisterns use, since a siphon's all-or-nothing action makes a genuine short flush difficult to achieve, whereas a valve can simply be held open for a shorter or longer period.

The flush valve tells a different story. If water is draining slowly from the cistern into the pan even when nobody has touched the button or handle, the flush valve seal or siphon washer has likely perished and is no longer sealing the outlet at the base of the tank. This shows up as a cistern that refills every few minutes with no obvious trigger, sometimes described by customers as topping itself up rather than running continuously. On older gravity-fed systems built around a siphon rather than a valve, a split diaphragm inside the siphon body produces the same symptom.

You can find out more via plumbers merchants.

A close-coupled cistern bolts directly onto the back of the pan with no visible pipework between the two. Because the outlet on the cistern base sits directly above the inlet on the pan, the flush valve or plumb2u.com siphon needs a shorter outlet and often a rubber doughnut washer to seal the joint rather than a length of pipe. Fill valves on close-coupled units tend to be shorter in the body too, since there is less depth inside a compact tank.

Bottom-fix hinges are the traditional arrangement, with a bolt passing down through the pan from above and a nut and washer tightened from underneath the rim. This means access is needed both above and below the pan to fit or remove the seat, which is straightforward on a floor-standing toilet but considerably more awkward on a wall-hung pan where the underside is harder to reach, or where a previous fitting has corroded the nut solid against the porcelain.