• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Before placing an order, it pays to note three things on site: whether the cistern sits flush to the pan or is wall-mounted above it, the fill valve's body length if there is a tight fit inside the tank, and whether the existing lever operates through the lid or via an external arm. Plumb2U carries fill valves, flush valves and levers suited to both close-coupled and low-level cisterns, stocked at trade prices for plumbers who need to get the right part on the first order rather than the second. Trade supplies despatch from Plumb2U's Epsom base to plumbers across the UK, and Plumb2U remains a straightforward call when the cistern type is not obvious from the pan alone.

The flush plate itself is usually the first point of failure a customer notices, whether that is a button that has stopped actuating, a plate that has come loose from the wall, or a dual-flush mechanism that only performs a full flush regardless of which button is pressed. Because the plate connects to the cistern through a spindle or cable rather than sitting directly on top of it, the fault could sit at the plate, along the linkage, or at the flush valve itself, and each of those needs a different part.

The flush valve tells a different story. If water is draining slowly from the cistern into the pan even when nobody has touched the button or handle, the flush valve seal or siphon washer has likely perished and is no longer sealing the outlet at the base of the tank. This shows up as a cistern that refills every few minutes with no obvious trigger, sometimes described by customers as topping itself up rather than running continuously. On older gravity-fed systems built around a siphon rather than a valve, a split diaphragm inside the siphon body produces the same symptom.

When a full lever replacement is needed, the fitting type has to match what is already there. Side levers, which mount through a hole in the side of the cistern, come in different thread diameters and in both metal and plastic bodies, and the arm length inside the tank needs to reach the flush valve or siphon without fouling the tank wall. Levers that mount through the lid, more common on close-coupled and concealed designs, connect via a spindle rather than a side arm and are not interchangeable with side-lever fittings.

Explore this further at Plumb2U Epsom trade counter.

Plenty of cisterns still in service across the UK do not use a flush valve at all in the modern sense, relying instead on a siphon mechanism that has been the standard gravity-fed flushing method in British toilets for decades. Understanding how a siphon works, and how it differs from a flush valve, matters because the failure signs and the fix are not the same.